This is a newly designed Pellet stove with advanced Italian designed and has individual fresh air input and venting system. Negative pressure burning technology causes high efficiency and little ash outlet during burning. It will be shut off automatically by wrong burning or out of fuel. Large BTU, quick heating and low fuel cost are its advantages.
Here after are the Main parameter:
|
Model |
Maximum |
Minimum |
|
|
Rating input (kw) |
8 |
6 |
|
|
Rating fuel consumption (kg/h) |
1.6 |
1.3 |
|
|
Heating area (m2) |
~100 |
~80 |
|
|
Rating voltage (V) |
230 |
230 |
|
|
Rating frequency (Hz) |
50-60 |
||
|
Rating power (W) |
<＝100 |
||
|
Hopper Capacity (kg) |
32 |
||
|
Venting pipe diameter (mm) |
∮76 （80） |
||
|
Air input pipe diameter (mm) |
80X40 (∮50) |
||
|
Unit size(length*wide*high) (mm) |
510*573*1029 |
||
|
Weight Kg |
109 |
||
|
Lighting |
This stove is equipped with an electric self igniter for ease of ignition. |
||
|
Efficiency: |
85% |
||
|
Thermostat |
This stove can be operated manually. |
||
|
Ignition time |
Around 2.5 Minutes |
||
Color for Gold, Black, Nickel, Red, Beige are avaible.
Certificate: CE certified
Container loading qty: 40/90/96pcs for 20/40"/40HQ
IGNITER
The STOVE comes equipped with an automatic igniter for lighting the fuel when the stove is in lighting mode . The igniter heats wood pellet directly through the burn pot and then lighted by the combustion blower. The igniter remains energized for the first eight minutes of the lighting sequence.
VACCUM SWITCH
The STOVE has s vacuum switch located behind the left door, fastened to the base. If a low pressure is created in the firebox by a leak, opening the front door, a blocked flue, or unsealed ash drawer, the vacuum switch will sense it and cause the stove to go into a shutdown mode.
AUGER AND AUGER MOTOR
The 7 RPM auger motor turns the auger, lifting pellets up the auger tube. The pellets are then dropped down a tube and into the firepot. The auger is controlled by the control board.
OVER TEMPERATURE SNAP SWITCH (MANUAL RESET)
This switch is installed on the vent pipe and slower the feeding speed if it senses excessive temperatures. This snap switch has a reset button on the mother board.
CONVECTION BLOWER SNAP SWITCH
This switch is installed on the vent pipe and turns the convection blower on when the stove gets up to temperature (30 degrees). Besides, switch off the stove when the temperature goes below 30 degrees
